HP xw8400 Workstation Hardware Setup Manual page 34

3 Setting Up Video Hardware
Autodesk Effect or Editing Product Version Certified PCI-X Firmware Version
2008
2008 SP1
Verifying the Current PCI-X Firmware Version
The following procedure describes how to verify the AJA OEM-2K board's PCI-X firmware
version.
To verify AJA OEM-2K PCI-X firmware version:
Make sure the driver is loaded by typing:
cat /proc/driver/aja
The following output should appear:
AJA Driver Name: oem2k
Version: 4.1 Beta 11
Card #: 0
Board Version String: OEM 2K - Rev 0
PCI Version: 0x55
Board ID: 10196500
FPGA built on 2007/09/18 at 10:57:41
N :
If there is no aja file in /proc/driver, you are using an outdated driver or the driver is not
OTE
loaded and you must install the latest DKU for your workstation. Refer to the Autodesk Effects
and Editing 2008 Software Installation Guide for Linux Workstations.
Updating PCI-X Firmware
The following procedure describes how to update the AJA OEM-2K board's PCI-X firmware to
the certified version required by your Autodesk Effects or Editing application.
To update AJA OEM-2K PCI-X firmware:
Log in as root and open a terminal.
1.
2. Insert the DKU CD in the CD-ROM drive.
3. Mount the CD-ROM by typing:
mount /mnt/cdrom
N :
If your workstation has multiple CD-ROM drives, the drive containing the DKU CD may
OTE
not be mapped as /mnt/cdrom. You can use any mapped CD-ROM drive for this procedure by
using the appropriate mount point for the CD-ROM drive in your workstation in these steps.
28
0x50
0x55