Timescan Audio - JVC DD868EU Instructions Manual

TimeScan
Names of
special-effects
playback
-9x -7x -5x -3x
Speed SP
Speed LP
Audio output
** Still mode cannot be engaged using the remote control's
pressing the PAUSE button.
When noise appears or the upper or lower part of the picture is distorted during TimeScan search, press
tracking with TV PROG + or – button.
The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
To resume normal playback, press PLAY.
When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change in the correct step if it is turned
too fast.
Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
Picture may appear distorted in comparison to normal playback.
Depending on the tape in use, noise may appear or the upper part of the picture may be distorted.
In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
TimeScan sound quality will differ in comparison to normal playback.
When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 2x
normal speed, the audio playback may be faster than normal.
When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
TimeScan does not work with NTSC playback.
If you don't want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF" (See below).

TimeScan Audio

The audio output can be set ON/OFF during TimeScan. Select ON/OFF as required.
* The default setting is "ON".
1
Press MENU to access the Main Menu screen.
Move the highlight bar (pointer) to "MODE SET" by pressing %fi, then press OK or
2
3
Move the highlight bar (pointer) to "TIME SCAN AUDIO"
by pressing %fi, then press OK or
4
Press MENU to return to the normal screen.
Reverse
Search Play
-1x
-7x -3x
Audio is output.
#
to select "ON" or "OFF".
Slow-Motion *Still
-1/6x -1/18x 0
-1/6x -1/18x 0
Audio is not Audio is
output. output.
@
MODE SET
B. E. S. T.
PICTURE CONTROL
AUTO TIMER
O. S. D.
DIRECT REC
AUTO SP=LP TIMER
POWER SAVE
NEXT PAGE
[5∞] =
[MENU] : EXIT
Forward
Slow-Motion Play
1/18x 1/6x 1x
1/18x 1/6x 1x
Audio is not
Audio is output.
output.
#
or button. Still mode can be engaged by
#
.
PREVIOUS PAGE
ON AV2 SELECT
AUTO COLOUR SYSTEM PAL/NTSC
OFF TIME SCAN AUDIO
ON
ON
OFF
OFF
[5∞] =
[MENU] : EXIT
19
EN
Search
2x 3x 5x 7x 9x
2x 5x 9x
and adjust
AV2
ON