Energy Saving; Water Softener Filter; Installing The Filter; Removing And Replacing The Filter - DèLonghi ECAM22.110 Instructions For Use Manual

eNeRGY SAVING

r
Use this function to enable or disable energy saving mode.
When enabled, the function reduces energy consumption in
compliance with European regulations.
Energy saving mode is active when the green ECO light is on
(fig. 7).
1. With the appliance off and the main switch in the I
position (fig. 3), press the
until the eCO light comes on (fig. 7).
2. To disable the mode, press the
the dial). The eCO light flashes.
3. To re-enable the mode, press the eCO button (on the left
of the dial)
4. Press the
confirm the selection. The eCO light goes off.
Please note :
e
A few seconds may elapse between energy saving mode
and delivery of the first coffee as the appliance must heat up
again.

WATeR SOFTeNeR FILTeR

Certain models are fitted with a water softener filter. If this
is not the case with your model, you are recommended to
purchase one from De'Longhi Customer Services.
Important:
2
• Keep in a cool dry place out of direct sunlight.
• After opening the pac,, use the filter at once.
• Remove the filte before descaling the machine.
To use the filter correctly, follow the instructions below.
n

Installing the filter

1. Remove the filter from packaging and rinse the filter with
about half a litre of tap water (fig. 8).
2. Rotate the calendar disk so that the next two months are
-
displayed (fig. 9).
Please note:
The filter lasts about two months if the appliance is used
normally. If the coffee maker is left unused with the filter
installed, it will last a maximum of three weeks.
3. Remove the tank from the appliance and fill with water
o
(fig. 1A).
4. Insert the filter in the water tank and immerse it
completely, sloping it to enable the air bubbles to escape
(fig. 10).
5. Insert the filter in the filter housing and press as far as it
will go (fig. 11).
button and hold it down
button (on the left of
again. The eCO light comes on steadily.
button (on the right of the dial) to
6. Close the tank with the lid (fig. 12), then replace the tank
in the machine.
7. Place a container (min. capacity: 100 ml) under the
cappuccino maker.
8. Turn the steam dial in position I to deliver hot water.
9. Let the appliance to deliver hot water for a few seconds, til
the delivery flows regulary, then turn the dial in position 0.
Please note:
It may happen that a single hot water is not sufficient to install
the filter: the lghts
In this case, repeat the installing operation from step 8.
The new filter is active and you can now use the coffee maker.

Removing and replacing the filter

After rwo months (see date indicator) or when the appliance
has not been used for 3 weeks, you should remove the filter
and replace with a new one, proceeding as described at the
previous paragraph.

mAkING COFFee

Selecting the coffee taste

Turn the coffee taste selection dial (B6) to set the required
taste. Turning it clockwise increases the quantity of coffee
beans the appliance will grind and therefore the strength of
the coffee obtained.
Turn the dial to MIN for an extra mild coffee and to MAX for an
extra strong coffee.
Please note :
• The first time you use the appliance, you will need to make
a number of coffees to identify the correct dial position
through trial and error.
• Do not turn the dial too far towards MAX, otherwise the
coffee may be delivered too slowly (a drop at a time),
particularly when making two cups of coffee at the same
time.
11
come on.