Using The Appliance For The First Time; Turning The Appliance; Turning The Appliance Off; Auto-Off - DèLonghi ECAM22.110 Instructions For Use Manual

Hide thumbs Also See for ECAM22.110:
Table of Contents

Advertisement

Using the appliance for the first time

Please note :
Coffee has been used to factory test the appliance and it
is therefore completely normal for there to be traces of
coffee in the mill.
The machine is, however, guaranteed to be new.
• You should customise water hardness as soon as possible
following the instructions in the section "Setting water
hardness" on page 16.
Follow the instructions:
1. Remove the water tank, fill to the MAX line with fresh
water (fig. 1A) then put back in the appliance (fig. 1B).
2. Place a container with a minimum capacity of 100 ml
under the cappuccino maker (fig. 2).
3. Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(fig. 3).
4. The
light flashes on the control panel (fig. 4).
5. 5. Turn the steam dial to the "I" position (fig. 5). The
appliance delivers water from the cappuccino maker then
goes off.
6. Turn the steam dial to the "0" position.
The coffee maker is now ready for normal use.
Please note :
When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before the
appliance starts to give satisfactory results.
TURNING The APPLIANCe ON
Please note :
Before turning the appliance on, make sure the main
switch on the back of the appliance is in the I position (fig.
3).
Each time the appliance is turned on, it performs an
automatic preheat and rinse cycle which cannot be
interrupted. The appliance is ready for use only after
completion of these cycles.
Danger Of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
To turn the appliance on, press the
corresponding
light flashes while the appliance is
heating up and performing an automatic rinse cycle (by
circulating hot water, the appliance heats both the boiler
and the internal circuits).
The appliance is at temperature when the
the lights corresponding to the coffee buttons come on.

TURNING The APPLIANCe OFF

Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger Of burns!
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the
appliance performs a rinse cycle, then goes off.
Please note :
If the appliance is not used for an extended period, also place
the main switch in the 0 position (fig. 3).
Important!
To avoid damaging the appliance, do not place the main switch
(fig. 3) in the 0 position until the appliance has been turned off
using the

AUTO-OFF

The appliance is set to turn off automatically if not used for 2
hours.
The time can be changed so that the appliance switches off
after 15 or 30 minutes, or after 1, 2 or 3 hours.
The set the auto-off, proceed as follows:
1. With the machine off and the main switch in I position
(fig. 3), press the
lights on the control panel come on.
2. Press the
until the lights corresponding to the number of hours be-
fore the appliance goes off automatically come on:
15 minutes
30 minutes
1 hour
2 hours
3 hours
3. Press the
confirm; the lights switch off.
(fig. 6): The
10
button (fig. 6). The
button.
button and keep it pressed until the
button (on the left side of the dial) until
eCO
eCO
eCO
eCO
eCO
button (on the left side of the dial) to
light goes off and

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents