Description Of Lights; Preliminary Checks; Checking The Appliance; Installing The Appliance - DèLonghi ECAM22.110 Instructions For Use Manual

Description of lights

f
eCO
Light flashing: the machine is heating up or a
rinse cycle is underway.
The appliance is delivering one or two cups of
espresso coffee.
The appliance is delivering one or two cups of
long coffee.
Light on steadily: the "steam" function has
been selected;
Light flashing: you must turn the steam dial.
An alarm is displayed on the control panel (see
the section: "Explanation of lights" on page
17).
Light on steadily: the grounds container is
missing and must be inserted in the appliance;
Light flashing: the grounds container is full and
must be emptied.
Light on steadily: the water tank is missing;
Light flashing: there is not enough water in the
tank.
Light flashing: the appliance must be descaled
(see the section "Descaling").
Light on steadily: the appliance is performing
a descaling cycle.
ECO "Energy Saving" mode is active.

PReLImINARY CheCkS

Checking the appliance

After removing the packaging, make sure the product is
complete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged.
Contact De'Longhi Customer Services.

Installing the appliance

Important!
When installing the appliance, respect the following safety
warnings:
• The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the
temperature could drop below freezing point.
• The appliance gives off heat.
After positioning the appliance on the worktop, leave
a space of at least 3 cm between the surfaces of the
appliance and the side and rear walls and at least 15 cm
above the coffee maker.
• Water penetrating the coffee maker could cause damage.
Do not place the appliance near taps or sinks.
• Arrange the power cable in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).

Connecting the appliance

Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional.
9