Measuring Water Hardness; Set Water Hardness; Technical Specification - DèLonghi ECAM22.110 Instructions For Use Manual

The descale programme automatically performs a series
of rinses and pauses to remove the limescale.
It is normal for several minutes of inactivity to elapse
between rinses.
After about 30 minutes, the water tank is empty and the
and lights flash. Turn the steam dial clockwise as far as it
will go to the 0 position.
The appliance is now ready for rinsing through with clean
water.
7. Empty the container used to collect the descaler solution
and replace it empty under the cappuccino maker.
8. Remove the water tank, empty, rinse under running
water, fill with clean water and replace. The
flashes.
9. Turn the steam dial anticlockwise to the I position (fig. 5).
Hot water comes out of the spout.
10. When the water tank is completely empty, the
flashes.
11. Turn the dial to the 0 position. The
off.
Fill the water tank again and the machine is ready for use.
SeTTING WATeR hARDNeSS
Descaling is necessary after a period of operation established
according to the water hardness set.
The machine is factory set for a hardness value of 4.
The machine can also be programmed according to the
hardness of the mains water in the various regions so that the
machine needs to be descaled less often.

measuring water hardness

1. Remove the "TOTAL HARDNESS TEST" indicator paper
attached to this manual from its pack.
2. Immerse the paper completely in a glass of water for one
second.
3. Remove the paper from the water and shake lightly.
After about a minute, 1, 2, 3, or 4 red squares form,
depending on the hardness of the water. Each square
corresponds to one level.
Level 1
Level 2
Level3
Level 4

Set water hardness

1. Make sure the appliance is off (but connected to the
mains electricity supply and with the main switch in the I
position);
2. Press the
6 seconds. The
together;
3. Press the
actual water hardness as measured by the indicator
paper.
Level
light
light
4. Press the
light goes
confirm the selection.
The machine is now reprogrammed with the new water
hardness setting.

TeChNICAL SPeCIFICATION

Voltage:
Absorbed power:
Pressure:
Water tank capacity:
Size LxHxD:
Cable length:
Weight:
Coffee beans container capacity:
directives:
• Stand-by Directive no. 1275/2008;
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent
amendments
• Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.
16
button and hold it down for at least
and
button (on the left of the dial) to set the
Level Level
1 2 3
button (on the right of the dial) to
220-240 V~ 50/60 Hz max. 10A
The appliance complies with the following EC
lights come on
Level
4
1450W
15 bars
1.8 litres max.
238x340x430 mm
1.15 m
9.1 kg
250 g max.