Installing Countertop Dispensers - Follett C/E25CT400A/W-S Installation, Operation And Service Manual

Installing countertop dispensers

Dispensers with top mount icemakers cannot be mounted on legs. They must be bolted to
!
counter. Use gloves when lifting icemaker to protect hands from sheet metal edges.
1. Position dispenser in desired location, mark
dispenser outline on counter and remove
dispenser.
2. Drill four 10mm (3/8") holes in counter
(Fig. 2) to anchor dispenser to counter.
Note: Follett countertop dispensers can
have any or all utilities run directly through
counter or out rear of dispenser. For
dispensers with any utilities exiting through
counter, make counter cut-out (Fig. 2)
3. If ice transport tube will exit out rear of
dispenser, remove ice transport tube knock-
out (Fig. 5G) from rear of dispenser.
Note: Utility connections can be accessed
through front of dispenser by removing
stainless steel splash panel,
or by removing access panel (Figs. 4, 5)
on back of dispenser.
4. If any electric utilities or water line will be connected through rear of dispenser, remove utility knock-out
(Figs. 4, 5F) from rear of dispenser and install supplied protective grommet.
5. If power is to be supplied through counter cut-out, complete steps 6-9. If power is to be supplied through
rear of dispenser, proceed to step 10.
Fig. 3 – Top view, dispenser plumbing connections countertop
drain pan
Fig. 2 – Counter cut-out, all models
534mm (21")
512mm (20.125")
13mm
(.5")
cut-out
229mm x 356mm
10mm (9" X 14")
holes
(.375")
10mm (.375")
DRAIN PAN
(L) 19mm (3/4") FPT dispenser drain
(K) alternate 19mm (3/4") dispenser
drain location
(G) 10mm (3/8") FPT water inlet
(J) 10mm (3/8") FPT condenser
water outlet
(H) 10mm (3/8") FPT condenser
water inlet
9
12mm (.44")
267mm
(10.5")
318mm
(12.5")
420mm
(16.5")
166mm
(6.5")
39mm (1.5")