Follett C/E25CT400A/W-S Installation, Operation And Service Manual page 8

Fig. 1 – Rear connections, freestanding models
(A) 10mm (3/8")
push-in water
inlet
11. Turn on water supply and check that water level in fl oat reservoir (when full) is within 7mm (1/4") of mark on
side of reservoir, and that fl oat moves freely. Check for leaks.
12 Verify that water sensor tabs are immersed in water in reservoir.
13. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull
forward.
14. If dispenser is equipped with SensorSAFE, remove protective plastic coating from dispense sensor labels.
15. Turn on dispenser power and bin signal rocker switches. Check dispenser and icemaker operation.
16. Sanitize icemaker according to instructions in icemaker manual. Discard sanitized ice.
17. Turn off icemaker bin signal switch.
18. Remove dispenser hopper lid; clean and sanitize dispenser according to instructions beginning on page 16.
19. Turn icemaker bin signal switch on and replace front covers, securing with screws.
267mm
(10.5")
171mm
800mm
(6.75")
(31.5")
79mm
(3.125")
19mm (3/4") MPT icemaker drain location (B)
(air-cooled only)
access panel
(19mm) 3/4" FPT drain (B)
power cord
20mm
(.8")
10mm (3/8") FPT condenser inlet location (D)
(water-cooled only)
10mm (3/8") FPT condenser outlet location (E)
(water-cooled only)
19mm (3/4") MPT icemaker drain location (C)
(water-cooled only)
384mm
(15.125")
259mm
(10.25")
79mm
(3.125")
8