Horizontal Terminations - Regency Horizon HZ40E-NG Owners & Installation Manual

Hide thumbs

Table Of Contents

Table of Contents

The minimum components required for a basic horizontal

termination are:

Horizontal Termination Cap

Elbow

Rigid Pipe Adaptor (510-994)

Wall Thimble

Length of pipe to suit wall thickness

(see chart)

Wall thickness is measured from the back standoffs to the inside

mounting surface of termination cap. For siding other than vinyl

furring strips may be used, instead of the vinyl siding standoff, to

create a level surface to mount the vent terminal. The Terminal

must not be recessed into siding. Measure the wall thickness

including furring strips.

If a Vinyl Siding Standoff is required (it must be used with vinyl

siding), measure to outside surface of wall without siding and

add 2 inches.

Flat Wall Installation

Wall Thickness

(inches)

4" - 5-1/2"

7" - 8-1/2"

10" - 11-1/2"

9" - 14-1/2'

15" - 23-1/2"

WARNING:

Do not combine venting components from

different venting systems.

However use of the the AstroCap

Riser is acceptable with all systems.

This product has been evaluated by Intertek

for using a Rigid Pipe Adaptor in conjunction

with Duravent Direct-Vent, Selkirk Direct-Temp,

Ameri Vent Direct Venting, ICC Excel Direct

and Security Secure Vent systems. Use of

these systems with the Rigid Pipe adaptor is

deemed acceptable and does not affect the

Intertek WHI listing of components.

The FPI AstroCap

and FPI Riser Vent terminal are certiﬁ ed for installations using FPI venting systems as well as Simpson Dura-Vent

American Metal Products Ameri Vent Direct Vent, Security Secure Vent

Fireplace Products International Ltd. Dura-Vent® and Direct Vent are registered and/or proprietary trademarks of Simpson Dura-Vent Co. Inc.

Regency Horizon™ HZ40E Gas Fireplace