Charger Base; Bsia System - Toshiba Strata AirLink Installation Manual

Maintenance and Troubleshooting
Troubleshooting

Charger Base

The Charger Base charges the handset and a spare battery. Do not have to remove the battery from
the handset to charge it. The LEDs indicate the status of the charging process as shown in
27.
Table 27 Charger Base LED Indications
LED
Red
Green
Amber
Amber/green

BSIA System

Reports
Strata AirLink Manager generates reports with troubleshooting information. Some of the reports
are:
o Alarm conditions
o Traffic statistics
o Line, channel, and call status
Analog Line Continuity
To check the analog line continuity throughout the system, use an installer test set at individual
MDF/IDF locations. Check for any bridge taps on the Base Station transmit/receive cables and
remove. Check all punch downs and cable connections.
DC Resistance
The distances between the system and its Base Stations (see
a local power supply, can be exceeded during an installation. The distances are reflected in the
resistance of the line.
➤ To measure the DC resistance
1. Use a digital multimeter that has resistance measuring capability in ohms and a basic accuracy
of better than one percent.
2. Use an RJ-11 female-to-female line adapter.
3. Ensure that all permanent wiring is done and all primary protectors are installed, if required.
For information on primary protection requirements for UL1459 compliance in the United
States, see
86
State
Steady Battery is rapid charging.
Internal battery fault. Charge the battery again. If the problem
Flashing
persists, replace the battery.
Steady Battery is charged and ready.
Battery is charged, but it could have reduced standby/talk time.
Flashing Try repeated rapid charging to rejuvenate the battery. Replace
the battery, if this fails to remedy the situation.
The charger is evaluating the handset or battery state, or waiting
Steady
for one battery to complete charging.
Short circuit or over-discharged battery is detected. Make sure
Flashing contacts are clean and allow the battery to remain in the charger
until rapid charging starts and completes.
Alternate flashing Battery is discharging.
"Primary and Secondary Protectors"
Meaning
Table 28), whether using line power or
on Page 102.
Strata AirLink Installation Guide
Table
5/00