Britax Baby Safety Capsule Instructions For Installation & Use page 8

HOW TO SET-UP
SETTING UP THE HARNESS
The Baby Safety Capsule is fitted with
two shoulder strap positions. As the baby
grows the shoulder straps must be moved
to the top slots. Refer to page 16 and 17
for correct fitment of the harness shoulder
straps.
A. Slacken Harness Straps by pressing
Harness Adjuster Strap Lock while
grasping both Lap Harness Straps and
pulling out desired amount of slack.
B. Slide the two harness tongues under
the Harness tongue holders. Move the
harness buckle away from the boss end
of the Carrier.
14
- Series number: 2030/A/2010
Instructions for Installation & Use
Press Harness
Adjuster Strap Lock
and pull Lap Harness
Straps to slacken.
Adjuster Strap Lock
Harness tongue holders
C. Place baby into Carrier lying on its back with head
towards boss end. Ensure that baby's arms and legs
are free. Make sure baby is dressed to allow Harness
Buckle to be pulled up between baby's legs e.g. a
jump suit.
Never wrap baby in a blanket before placing in the Baby
Safety Capsule.
D. See pages 24 to 27 for securing the child in the
harness after you have finished the set-up.
E. The Infant Carrier is fitted with two shoulder strap positions. As the
baby grows, the shoulder straps must be moved to higher slots.
The shoulder straps must be
in the slots which are nearest
to the child's shoulders, but
Boss
not lower than the child's
shoulders.
The shoulder straps must be in the slots which
are nearest to the child's shoulders, but not
lower than the child's shoulders.
Correct crotch strap position in line with baby's
crotch to prevent baby's bottom from slipping
further into Carrier.
Correct fitment of the harness is very important as it restrains the baby in the restraint. The
harness must fit firmly around upper torso of the baby and be positioned so as to leave the
baby's arms and legs free.
HOW TO SET-UP
- Series number: 2030/A/2010
Instructions for Installation & Use
Boss
Boss
15