How To Install - Britax Baby Safety Capsule Instructions For Installation & Use

HOW TO SET-UP
ANGULAR ADJUSTMENT OF CAPSULE
Some vehicle seats have more rearward slope than others. If the angle of the seat causes
the baby to be too upright for comfort, the angle may be altered by placing a firm packing
between the seat and the underside of the Base (packing can be a firmly rolled up towel or
nappy).
For car seats that are very flat, packing at the front will cause the Base to more reclined.
Do not remove all of the rearward slope by over packing. Always leave a rearward slope
angle of approximately 10 to 15 degrees.
10° to 15°
20
- Series number: 2030/A/2010
Instructions for Installation & Use
Packing
Consult the car owner's handbook for location of anchor fittings or anchorage points. Most
modern vehicle's already have an anchor fitting fitted in the car.
An anchor fitting is required to attach the upper anchorage strap to fully install the Carrier to
the car. The upper anchorage strap must be used with this infant carrier when used in the
car.
For installing the Base to the car, select a seating position with a child restraint anchor fitting
directly behind the seating position.
If there is no child restraint anchor fitting or child restraint anchor point refer to page 38 for
the installation of the anchor fitting as well as the use of extension straps.
INSTALLING BASE INTO VEHICLE
A. Place the Base into the vehicle at the selected
seating position with the "PRESS" catch end
against the seat as shown below. Extend the
seat belt to maximum length. For lap-sash seat
belt, position the tongue in the middle of the fully
extended belt.
B. Feed the seat belt tongue through the slot on
the side of the Base closest to the seat belt
anchorage.
Instructions for Installation & Use

HOW TO INSTALL

A
REARWARD-
FACING SEATBELT
PATH
B
- Series number: 2030/A/2010
21