Britax Baby Safety Capsule Instructions For Installation & Use page 21

Hide thumbs Also See for Baby Safety Capsule:
Table of Contents

Advertisement

INSTALLATION OF CAR ANCHOR FITTING
IF THE CAR IS FITTED WITH CHILD
RESTRAINT ANCHORAGE POINT
Locate the anchorage point behind the rear seating
position. (consult the car owners handbook for the
location of the anchorage point). The anchorage
point should be directly behind and central to the
restraint. Remove thread plug from the parcel shelf/
floor/roof, etc. and install anchor bolt and fitting as
shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ANCHOR BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK
BOLT. MAXIMUM TORQUE IS 20 Nm. (14.75 ft.lb.)
Note: Minimum of five full turns of anchor bolt is
required before tightening force is applied.
40
- Series number: 2030/A/2010
Instructions for Installation & Use
UPPER ANCHORAGE FITTING
Fig.1.
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Front of Vehicle
INSTALLATION OF CAR ANCHOR FITTING
IF THE CAR IS NOT FITTED WITH
CHILD RESTRAINT ANCHORAGE
POINTS
For Sedans only - Drill 9mm diameter hole in the
parcel shelf on the centre line of the seating position
as shown in Fig 3. Before drilling the hole, check the
underside for accessibility. Install the anchor bolt as
shown in Fig 2.
For vehicles other than Sedans - In Australia,
consult your nearest child restraint fitting station
or traffic authority for vehicle inspection to find
the best, correct position for the placement of the
anchorage point, and for the correct attachment bolt
length and use of spacers. In New Zealand, consult
the agent for the vehicle.
Note to Queensland purchasers: The installation
of anchorage points must be approved by
authorised officers appointed by Queensland
Transport. Authorised officers can be sourced from
all Queensland Transport Customer Service and
Queensland Ambulance Service Centres.
Instructions for Installation & Use
UPPER ANCHORAGE
FITTINGS FOR SEDANS
ONLY
Fig.2.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Reinforcing
washer (cone
downwards)
Lock washer
Front of Vehicle
- Series number: 2030/A/2010
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents