Britax Baby Safety Capsule Instructions For Installation & Use page 22

Hide thumbs Also See for Baby Safety Capsule:
Table of Contents

Advertisement

INSTALLATION OF CAR ANCHOR FITTING
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE
BOLT IS NOT THE CORRECT LENGTH THE CAR
MANUFACTURER'S HAND BOOK CAN PROVIDE
ADVICE ON THE CORRECT LENGTH BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO
UNSOUND METAL OR TO WOOD, OR SYNTHETIC
STRUCTURES. WHEN DRILLING 9 MM HOLE DO
NOT DRILL THROUGH FUEL LINES, FUEL TANKS,
ELECTRICAL WIRING, OR RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM
SHARP CORNERS AND EDGES. THE ANCHOR
FITTING MUST BE USED ONLY AS DESCRIBED
ABOVE. IT MUST NOT BE HOOKED ONTO ANY
OTHER OBJECT.
CAR INSTALLATION ACCESSORIES
(From retailers of Safe-n-Sound products)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038
EXTENSION STRAPS: May be required for cars without a fixed parcel shelf.
Re-order no: 0035 (length 300mm) or
0036 (length 600mm)
GATED 3-BAR SLIDE (Locking clip): For converting lap-sash seat belt to lap belt, and to
obtain a better fit to the car where the fitted lock-off may not be suitable. Most cars will not
need this, Re-order no: 0215.
42
- Series number: 2030/A/2010
Instructions for Installation & Use
Note: Marking on
the top of a Grade 5
Bolt.
Front of Vehicle
200mm
min.
Fig.3.
Centre line of
seating position
ALTERNATIVE INSTALLATION IF SEATBELT LOOSENS
LAP-SASH SEAT BELT
If a seat belt will not stay tight, then a
Gated 3-Bar Slide may be used to prevent
loosening.
There may be two types of Gated Slides
available, Curved and Flat.
Before installing the restraint, join the
lap-sash seat belt by using the Gated 3-Bar
Slide stored under the carrier.
A. Hold the lap and sash straps together and fold as shown.
Slide the inner strap into the Gated 3-Bar Slide followed by the
outer strap.
B. The two straps should slide freely in the Gated 3-Bar Slide slot.
C. Repeat previous step A for the other
slot in the Gated 3-Bar Slide.
Instructions for Installation & Use
Flat
Curved
Inner
strap.
Faces
towards
restraint.
Hollow side
Ensure the Lap portion of seat
belt is nearest to the restraint.
- Series number: 2030/A/2010
43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents