Table of Contents
Advertisement
Working Instruction Repair Instruction Mechanical/3/000 21-1/FEA 209 544/123, Mechanical
4.1.3 Dome foil Assembly Installation
Connect the dome foil assembly's flex film connector to the
circuit board.
Insert the camera switch portion of the dome foil assembly
into place between the circuit board and camera key.
Make sure the camera key remains in its proper
location.
Rotate the dome foil assembly down over the circuit board
so that that two alignment pins pass through the two holes
at the top of the dome foil assembly as shown.
: Preliminary
60(65)
State
Rev 4
© Sony Ericsson Mobile Communications AB
Advertisement
Table of Contents
