Activating The Dsp Modes - JVC RX-7000VBK Instructions Manual

5. Press TEST again to stop the test tone.
6. Press EFFECT to select an effect
level you want.
• Each time you press the button, the effect
level changes as follows:
DSP EFFECT 1 DSP EFFECT 2
DSP EFFECT 5
As the number increases, JVC Theater Surround becomes
stronger.
On the front panel:
You can also use the buttons on the front panel to adjust the
Surround modes. However, no test tone is available when using the
buttons on the front panel. So, make adjustments while listening to
the sound of the source played back.
1. Press DSP MODE repeatedly until
"THEATER" appears on the
display.
The Ÿ PRO LOGIC and DSP indicators also light up on the
display.
2. Adjust the speaker output levels.
1) Press BALANCE/SURROUND
ADJUST repeatedly until one of the
indications appears on the display.
"CENTER LEVEL":
To adjust the center speaker level.
"REAR L LEVEL":
To adjust the left rear speaker level.
"REAR R LEVEL":
To adjust the right rear speaker level.
2) Turn MULTI JOG to adjust the
selected speaker output level (from –10
dB to +10 dB).
3) Repeat 1) and 2) to adjust the other
speaker output levels.
TEST
4
EFFECT
7
/P
DSP EFFECT 3
DSP EFFECT 4
DSP MODE
BALANCE/SURROUND
ADJUST
MULTI JOG
3. Adjust the effect level.
1) Press BALANCE/SURROUND
ADJUST repeatedly until "DSP
EFFECT" appears on the display.
The display changes to show the current
setting.
2) Turn MULTI JOG to select the effect
level.
As you turn it, the effect level changes as
follows:
DSP EFFECT 1 DSP EFFECT 2
DSP EFFECT 5
As the number increases, JVC Theater Surround becomes
stronger.

Activating the DSP Modes

You can use only one DSP mode at a time. When a DSP mode is
activated, another DSP mode is canceled if in use.
For Dolby Pro Logic, Dolby Digital, and DTS
Digital Surround
1. Press SURROUND ON/OFF so that the lamp on
the front panel button lights up.
• Each time you press the button, the Dolby/DTS Surround turns
on and off alternately.
SURROUND ON/OFF
On the front panel
2. Select and play a sound source.
• To enjoy Dolby Pro Logic, play back a software encoded with
Dolby Surround and labeled with
• To enjoy Dolby Digital, play back a software encoded with
Dolby Digital and labeled with
• To enjoy DTS Digital Surround, play back a software encoded
with DTS Digital Surround and labeled with
To cancel the Dolby/DTS Surround mode
Press SURROUND ON/OFF again so that the lamp on the front
panel button goes off. ("SURROUND OFF" appears on the display.)
SURROUND ON/OFF
On the front panel
BALANCE/SURROUND
ADJUST
MULTI JOG
DSP EFFECT 3
DSP EFFECT 4
SURROUND
ON/OFF
On the remote control
mark.
DOLBY SURROUND
mark.
D I G I T A L
mark.
SURROUND
ON/OFF
On the remote control
27