SB upper case
・ Press the pop-up lever A part of the top cover unit so that the built-in SB pops up.
・ Take out 2 screws (#629).
・ Push from beneath the hooking lever of the SB upper case as shown in Fig.1 . Then slide 2 hooks in the
direction of the arrow to remove the lever.
・ Deactivate pop-up of the SB lower case unit, and remove the SB upper case. (Fig.2)
Pop-up lever A part
・ Remove the tape (#709).
・ Remove the optical fiber (#470) from the sensor.
Hooking lever
Fig.1
#629×2
SB lower case unit
#470
Optical fiber
#709
- D8 ・
Fig.2
Note) Both ends of the optical fiber are just
inserted in each part without any adhesive.
-
VBA12001-R.3668.A
SB upper case