SOYO SY-P4I875P DRAGON 2 V1.0 User Manual page 128

Note: That flashing from the BIOS is only possible if you use a normal floppy drive.
It can't flash from any other device.
After flashing the BIOS, my system will not boot-up.
1. Try clearing the CMOS ram.
2. The BIOS chip is defective due to an unsuccessful flash, contact
your nearest SOYO branch for re-flashing.
Is there a way to reprogram my BIOS after an unsuccessful flash?
No other way, you need to send back the BIOS ROM to your nearest SOYO
branch for re-flashing.
I'm using a 400 or 533 MHz FSB CPU, I cannot find the DDR 200MHz
option in the BIOS, why?
An 800 MHz CPU should be used if you want your memory to run at DDR
400 (PC3200).
VGA Issue
I cannot set my VGA to go higher than 16 color (640x 480).
1. Make sure that you have installed the Intel Inf driver.
2. Install/ re-install the VGA driver.
After wake-up from Suspend to RAM or Standby mode, the screen has
no display but I can hear the hard disk operating
Check the VGA card manufacturer for a driver update and VGA BIOS update,
make sure the VGA card supports the Suspend to Ram function.
Audio Issue
How can I disable the on-board Audio?
Go to the SOYO Combo Feature menu in the BIOS setup, then set the
"onboard audio" to disable.
123