SOYO SY-P4I875P DRAGON 2 V1.0 User Manual page 115

Warning Make sure the data in drives is no longer in use before creating
:
RAID Array.
5. Next, the Array Name input line appears for the user to key in a name
for the newly created array. The effective characters for an array name
is '0'-'9', 'A'-'Z', 'a'-'z', space and underscore.
After the RAID array has been created successfully, its information
6.
shows up at RAID Array List .
Note: RAID 0 cannot be used for parallel ATA drives connected at the same
channel. RAID 0 cannot be used for mixed parallel and serial ATA drives.
2.2.2 Create RAID 1 Mirroring for Reliability
1. Press 'Enter' key to activate this item. An ' M ' flash cursor appears at the
' Drive Select Menu ' for the user to choose the first drive for RAID 1.
2. Use 'Space' key to choose the desired drive for RAID 1. Then flash
cursor changes to an ' m ' flash cursor for the user to choose the second
drive for RAID 1.
3. The prompt 'Create RAID 1(Y/N)' appears after two drives are properly
assigned.
4. Press 'Y', and then some necessary information will be written to drives,
which maybe destroy the original data in the drives.
Warning: Make sure the data in drives is no longer in use before creating
RAID Array.
5. Next, the Array Name input line appears for the user to key in a name for
the newly created array. The effective characters for an array name is
'0'-'9', 'A'-'Z', 'a'-'z', space and underscore.
6. After the RAID array has been created successfully, its information
shows up at RAID Array List .
110