Replacing A Ramp Pivot - Precor EFX 885 Service Manual

Procedure 10.20 Replacing a Ramp Pivot
Procedure
1. Raise the incline to its highest position.
2. Remove the four bolts that fasten the ramp pivot to the ramp. Refer to Diagram 10.21.1.
Diagram 10.21.1 - Rear Ramp Mounting
3. Remove the two pivot bolts, washers and steel spacers from the ramp pivot.
4. Remove the ramp pivot from the ramp.
5. Set the replacement ramp pivot in its mounting and hand start, but do not tighten, the four mounting bolts
and washers removed in step 2.
6. Slide the two steel spacers into the ramp pivot, hand start the two pivot bolts and washers removed in step
3.
7. Torque the four mounting bolts to 480 inch pounds (40 foot pounds).
8. Torque the two pivot bolts to 780 inch pounds (65 foot pounds).
9. Thoroughly, test all incline functions.
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Mounting
Bolt
Pivot Bolt
EFX 885, 835, 825
Service Manual 20039-166
Ramp
Pivot
Page 167