Fixing Installation Plate(Standard Type); Drill A Hole In The Wall - Heat Controller B-MMC09FA-1 Service Manual

Installation

Fixing Installation Plate(Standard Type)

The wall you select should be strong and solid enough to
prevent vibration
1. Mount the installation plate on the wall with
type "A" screws. If mounting the unit on a concrete wall,
use anchor bolts.
• Mount the installation plate horizontally by aligning the
centerline using a level.
2. Measure the wall and mark the centerline. It is also
important to use caution concerning the location of the
installation plate-routing of the wiring to power outlets is
through the walls typically. Drilling the hole through the
wall for piping connections must be done safely.
CHASSIS
(Grade)
A
S4 50
SE 65

Drill a hole in the wall

• Drill the piping hole with a Ø 70 mm (Ø 2.75 inch) hole core drill. Drill the piping hole at either the right or the left
with the hole slightly slanted to the outdoor side.
Indoor
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Distance (mm)
B C D
105 59 105
110 85 110
WALL
Outdoor
Installation Plate
Chassis
Hook
D
C
Ø70mm
Left rear piping
- 22 -
Type "A" screw
Installation plate
A
Right rear piping
LGE Internal Use Only
B
Ø70mm