Connecting Speakers - JVC GVT0052-008A Instructions Manual

AM (MW/LW) antenna
ANTENNA
1
AM EXT
AM LOOP
FM 75
COAXIAL
2
AM (MW/LW) loop
antenna (supplied)
1
Connect the AM (MW/LW) loop antenna to
the AM LOOP terminals as illustrated.
• If the AM (MW/LW) loop antenna wire
is covered with vinyl, remove the vinyl
by twisting it as shown in the diagram.
2
Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
(MW/LW) loop antenna must remain connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
– 7 –

Connecting Speakers

1
Speaker cords
(red/black)
RIGHT
Black
RIGHT
Speaker cords
(blue/black)
Right speaker
1
Open the speaker terminals on the rear of the
unit.
2
Insert the end of the speaker cord into the
terminal.
Match the polarity (colors) of the speaker terminals: Red
(+) to red (+) and black (–) to black (–); Blue (+) to blue
(+) and black (–) to black (–).
3
Close the speaker terminals.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
3
2
Red
Speaker cords
SUBWOOFERS
(red/black)
LEFT
Black
LEFT
MAIN
SPEAKERS
CAUTION: SPEAKER
IMPEDANCE
6 16
Blue
Left speaker