Ford 1999 Windstar Owner's Manual page 123

Conditions of operation
If...
The driver's safety belt is not
buckled before the ignition
switch is turned to the ON
position...
The driver's safety belt is
buckled while the indicator
light is illuminated and the
warning chime is sounding...
The driver's safety belt is
buckled before the ignition
switch is turned to the ON
position...
Safety belt maintenance
Inspect the safety belt systems periodically to make sure they work
properly and are not damaged. Inspect the safety belts to make sure
there are no nicks, wears or cuts, replacing if necessary. All safety belt
assemblies, including retractors, buckles, front seat belt buckle
assemblies (slide bar)(if equipped), shoulder belt height adjusters
(if equipped), child safety seat tether bracket assemblies (if equipped),
and attaching hardware, should be inspected after a collision. Ford
recommends that all safety belt assemblies used in vehicles involved in a
collision be replaced. However, if the collision was minor and a qualified
technician finds that the belts do not show damage and continue to
operate properly, they do not need to be replaced, except as described in
the Replacing the second row bench seat belt assemblies after a
collision section of this chapter. Safety belt assemblies not in use during
a collision should also be inspected and replaced if either damage or
improper operation is noted.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
Refer to Cleaning and maintaining the safety belts in the
Maintenance and care section.
Seating and safety restraints
Then...
The safety belt warning light
illuminates for one to two minutes and
the warning chime sounds for four to
eight seconds.
The safety belt warning light and
warning chime turn off.
The safety belt warning light and
indicator chime remain off.
123