Connecting The Monitor - Denon S-302 Owner's Manual

ENGLISH
I
Connecting the Monitor
Select and connect using one of the video cables below according to the TV's terminals. The terminals
provide playback with different picture qualities, in the following order (from highest to lowest):
CDHDMI terminals, @Component video terminals, Q)S-Video terminals, @Video terminals
Switching the video output format
Set the
HDMI/PROGRESSIVE/INTERLACED
switch on the rear panel according to the video output format
of the TV connected to the set.
*
Be sure to turn the power off before operating the switch.
The component video terminals may be indicated differently on your TV. For details, see the TV's operating
instructions.
w,n
---:=1J.
li;::~~;~' ~
.
Wall bracket
(included)
•
~ ".
~----~
"'~~.
Screws •
(included)
~
Speaker Stand
(included)
I
Mounting the speaker stand and bracket
I
*
Be sure to tighten the screws completely.
*
Also be careful when installing.
"
1--"
Anti slip pads here.
*
When placing the speaker system (SC-S302) on a
stand, etc., stick the included cushion pads at the
two corners of the bottom surface. (Refer to the
illustration below.)
Note on speaker impedance
The protection circuit will be activated in the
following cases:
• When the speaker output is short-circuited
• When the temperature around the set is
extremely high
• When the set is used for long periods of time
with a high output and the internal temperature
rises
When the protection circuit is activated, the
speaker output is cut off and the power indicator
flashes. Should this occur, please follow these
steps: be sure to switch off the power of this unit.
check whether there are any faults with the wiring
of the speaker cables or input cables, and wait for
the unit to cool down if it is very hot. Improve the
ventilation condition around the unit and switch
the power back on.
If the protection circuit is activated again even
though there are no problems with the wiring
or the ventilation around the unit. switch off the
power and contact a DENON service center.
Protector circuit
If speakers with an impedance below the specified
impedance (4 OIohmsl are used (for example,
speakers with an impedance of 3 OIohms) with
the volume turned up high for long periods of
time, the temperature may rise, activating the
protective circuit.
When the protection circuit is activated, the output
to the speakers is cut off and the power indicator
blinks. If this happens, unplug the power supply
cord, wait for the set to cool off and improve
ventilation around the unit. Also check the wiring
of the input cables and the speaker cables. After
doing this, plug the power supply cord back in and
turn the unit's power back on.
If the protection circuit is activated again even
though there are no problems with the wiring
or the ventilation around the unit, switch off the
power and contact a DENON service center.
11