Denon S-302 Owner's Manual page 44

ENGLISH
I
2
Press
[CALL]
and
[REPEAn
at the same time.
The indicator starts flashing.
Number
TV
1
SAT/CABLE
2
VCR 3
No settina 0
Operating a component stored in the
preset memory
Setting the punch through function
"Punch Through" is a function allowing you to operate
[SOURCE CONTROLl
and [TV INPUT] on "TV'; "SAT/CABLE"
or "VCR" components when in the "OVO / CD / FM/AM /
iPod NET/USB" mode. By default, nothing is set.
1
Set
[SOURCE CONTROL]
to the component you want
to operate.
2
Operate the component.
*
For details, refer to the component's operating instructions.
*
Some models cannot be operated with this remote control unit.
1
Set
[SOURCE CONTROL]
to the component to be
registered (DVD / CD / FMlAM / iPod NET/USB).
3
Input the number of the component you want to set.
1
Set
[SOURCE CONTROL]
to the component to be
registered.
Setting the preset memory function
OENON and other makers of components can be operated
by setting the preset memory.
This remote control unit can be used to operate components
of other manufacturers without using the learning function
by registering the manufacturer of the component as
shown in the list of preset codes ( End of this manual).
3
Referring to the included list of preset codes (1Gr End
of this manual), press
[NUMBER] (0 -
9) to input the
preset code (a 3-digit number) for the manufacturer
of the component whose signals you want to store in
the memory.
4
To store the codes of another component in the
memory, repeat steps 2 to 3.
2
Press
[AUDIO/RDS]
and
[ZOOM/Rn
at the same
time.
The indicator starts flashing.
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• Operation is not possible for some models.
Remote Control Unit Operations
--
[SOURCE
----+----=-p
CONTROL]
l:'~i;::"
About the button names in these explanations
< > : Buttons on the main unit
[ 1 :
Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Signal transmission
indicator
[TVINPUn~
40