Connecting The Monitor; Connecting Equipment With Hdmi Connectors - Denon S-102 Owner's Manual

Connecting the Monitor

Select and connect using one of the video cables below according to the TV's terminals. The terminals
provide playback with different picture qualities, in the following order (from highest to lowest):
qHDMI terminals, wComponent video terminals, eS-Video terminals, rVideo terminals
Monitor
Switching the video output format
HDMI/PROGRESSIVE/INTERLACED
Set the switch on the rear panel according to the video output format
of the TV connected to the set.
b Be sure to turn the power off before operating the switch.
• The component video terminals may be indicated differently on your TV. For details, see the TV's operating
instructions.
• When PROGRESSIVE is set, picture cannot be output from VIDEO OUT/S-VIDEO OUT.

Connecting Equipment with HDMI Connectors

Digital video and digital audio can both be connected using a single HDMI cable.
NOTE
• When playing multichannel sources, the audio output is downmixed to two channels for output. In
addition, the sampling frequency is lowered to 48 kHz.
• Video signals are not output properly when using devices that are not HDCP-compatible.
•Use a cable on which the HDMI logo is indicated (a certified HDMI product) for connection to the HDMI
connector. Normal playback may not be possible when using a cable other than one on which the HDMI
logo is indicated (a non-HDMI-certified product).
• The audio signals output from the HDMI connector (sampling frequency, bit rate, etc.) may be restricted
by the connected device.
If the connected TV is only compatible with DVI-D terminals, use an HDMI/DVI conversion cable.
When connecting with an HDMI/DVI converter cable (adapter)
• HDMI video signals are theoretically compatible with the DVI format.
When connecting to a TV, etc., equipped with a DVI-D terminal, connection is possible using an HDMI/
DVI converter cable, but depending on the combination of components in some cases the video signals
will not be output.
• When connecting using an HDMI/DVI converter adapter, the video signals may not be output properly
due to poor connections with the connected cable, etc.
HDMI-compatible
Condition of signals
monitor
from the S-102's HDMI
output terminal
Both video and audio
output
DVI-D-compatible
DVI-D-compatible
monitor
monitor
(HDCP non
(HDCP compatible)
compatible)
Neither video nor audio
Only video outputz
output
z: Only output when video signals are of RGB format.
ENGLISH