Connecting The Am Antenna; Connecting The Speakers - JVC CA-V888T Instructions Manual

CAUTION: Make all connections before plugging the Unit into an AC power outlet.

Connecting the AM Antenna

GND
AM
LOOP
AM
EXT
1 2

Connecting the Speakers

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the
CA-V888T and the other end to the speaker.
1. Open each of the terminals and insert the speaker wires firmly (be sure to remove the insulation
2. Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–)
Right speaker
IMPORTANT: Use speakers with the correct impedance only. The correct impedance is indicated on
the back panel.
CAUTION: If a TV is installed near speakers, the TV may display irregular colors. In this case, set
the speakers away from the TV.
AM antenna wire (Not supplied)
Note: Even when connecting
an outside AM antenna,
keep the indoor AM loop
connected.
AM Loop Antenna
3
(Please refer to instructions for speakers as will when you connect speakers.)
at the end of each wire first), then close the terminals.
terminals marked RIGHT on the CA-V888T.
Connect the red (+) and black (–) terminals of the left side speaker to the red (+) and black (–)
terminals marked LEFT on the CA-V888T.
If reception is poor, connect the outside antenna.
Turn the loop until you
have the best reception.
SPEAKERS
RIGHT LEFT
+ +
– –
1 2
Snap the tabs on the loop
into the slots of the base to
attach the AM Loop.
Left speaker
3
5