JVC CA-VSDT6R Instructions Manual

Jvc compact component system instructions
Hide thumbs Also See for CA-VSDT6R:

Advertisement

COMPACT COMPONENT SYSTEM
VS-DT6R/VS-DT7R/VS-DT9R
Consists of CA-VSDT6R and SP-VSDT6
Consists of CA-VSDT7R and SP-VSDT6
Consists of CA-VSDT9R and SP-VSDT9
STANDBY/ON
1
2
3
PLAY MODE
4
5
6
REPEAT
9
7
8
FM MODE
10
+
10
BASS
TREBLE
SET
MD/AUX
CANCEL
PTY
PTY
TA/NEWS
SEARCH
SELECT
/INFO
DISPLAY
FM/AM
MODE
DIMMER
SLEEP
AHB PRO
DISPLAY
CLOCK
OPEN/
/TIMER
CLOSE
VOLUME
STANDBY/ON
1
2
3
PLAY MODE
4
5
6
REPEAT
9
7
8
FM MODE
10
+
10
BASS
TREBLE
SET
MD/AUX
CANCEL
PTY
PTY
TA/NEWS
SEARCH
SELECT
/INFO
DISPLAY
FM/AM
MODE
DIMMER
SLEEP
AHB PRO
DISPLAY
CLOCK
OPEN/
COLOR
/TIMER
CLOSE
VOLUME
SP-VSDT6
CA-VSDT6R
CA-VSDT7R
SP-VSDT9
CA-VSDT9R
INSTRUCTIONS
COMPACT COMPONENT SYSTEM
SP-VSDT6
COMPACT COMPONENT SYSTEM
SP-VSDT9
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT0853-009B
[B]

Advertisement

Table of Contents
loading

Summary of Contents for JVC CA-VSDT6R

  • Page 1 COMPACT COMPONENT SYSTEM VS-DT6R/VS-DT7R/VS-DT9R Consists of CA-VSDT6R and SP-VSDT6 Consists of CA-VSDT7R and SP-VSDT6 Consists of CA-VSDT9R and SP-VSDT9 STANDBY/ON PLAY MODE REPEAT FM MODE BASS TREBLE MD/AUX CANCEL TA/NEWS SEARCH SELECT /INFO DISPLAY FM/AM MODE DIMMER SLEEP AHB PRO...
  • Page 2: Important For Laser Products

    IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer.
  • Page 3: Safety Instructions

    “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been disigned and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮...
  • Page 4: Introduction

    I The controls and operations have been redesigned to make them very easy to use, freeing you to just enjoy the music. • With JVC’s COMPU PLAY you can turn on the System and automatically start the Radio or CD Player with a single touch.
  • Page 5: Table Of Contents

    Table of Contents Introduction ... 1 Features ... 1 How This Manual Is Organized ... 1 WARNINGS ... 1 IMPORTANT CAUTIONS ... 1 Getting Started ... 3 Accessories... 3 How To Put Batteries In the Remote Control ... 3 Connecting the FM Antenna ... 4 Connecting the AM (MW/LW) Antenna ...
  • Page 6: Getting Started

    Getting Started Accessories Make sure that you have all of the following items, which are supplied with the System. Power Cord (1) AM Loop Antenna (1) Remote Control (1) Batteries (2) FM Wire Antenna (1) Speaker Cords (2) Stand (1) (for Center Unit) Legs (2) (for Stand) Screw (1) (for Stand) Paper Pattern (1)
  • Page 7: Connecting The Fm Antenna

    CAUTION: • Make all connections before plugging the System into an AC power outlet. (Only if you install the Center Unit vertically) • To place the Center Unit vertically, the Stand and Legs must be attached. (See page 8.) To make connections, let the cords pass in the holes of the Stand as shown in the diagram before attaching the Stand and Legs.
  • Page 8: Connecting The Am (Mw/Lw) Antenna

    Getting Started Connecting the AM (MW/LW) Antenna Rear Panel of the Center Unit AM loop antenna (Supplied) Attach the AM loop to its base by snapping the tabs on the loop into the slot in the base. • The AM loop antenna can be attached to a wall. Screw (not supplied) •...
  • Page 9: Connecting The Speakers

    CAUTION: • Make all connections before plugging the System into an AC power outlet. • Handling the speakers As this is a precision instrument, handle it carefully so as to protect it from shocks. Connecting the Speakers These speakers are exclusively for this system. Using with other devices will damege the speakers. 1.
  • Page 10: Connecting A Subwoofer

    Getting Started Connecting a Subwoofer Connect a signal cord (not supplied) between the System’s SUBWOOFER terminal and the input terminal of an external sub- woofer. Subwoofer (not suipplied) Connecting External Equipment Connect signal cords (not supplied) between the System’s MD/AUX-OUT/IN terminals and the output/input terminals of the external MD recorder, tape deck, etc.
  • Page 11: Connecting An Md Recorder, Etc (Digital Output)

    Firmly insert the supplied AC power cord into the AC inlet on the back of the Unit. CAUTIONS: • ONLY USE THE JVC POWER CORD PROVIDED WITH THIS SYSTEM TO AVOID MALFUNCTION OR DAMAGE TO THE SYSTEM. • BE SURE TO UNPLUG THE POWER CORD FROM THE OUTLET WHEN GOING OUT OR WHEN THE SYSTEM IS NOT IN USE FOR AN EXTENDED PERIOD OF TIME.
  • Page 12: Installing The Equipment On The Wall

    Getting Started Installing the Equipment on the Wall The Center Unit and Speakers can be attached to a wall. CAUTIONS: Attachment to a wall • The Center Unit weighs approximately 4.3 kg. When its buttons are operated, an additional force will be applied to it in the downward direction.
  • Page 13: Changing The Display And Control Buttons Settings

    Example of attachment (Speakers) (SP-VSDT6 only) The speakers can be attached to a wall. Attach a screw (not supplied) on the wall, then hook the speaker onto the screw. • Do not place anything on top of the Center Unit. Doing so may cause the Center Unit to fall, causing malfunctioning and/or injury. •...
  • Page 14: Using The Remote Control

    COMPU Play JVC’s COMPU PLAY feature lets you control the most frequently used System functions with a single touch. With One Touch Operation you can play a CD, turn on the radio, or listen to an external equipment with a single press of the play button for that function.
  • Page 15: Basic Operations

    Basic Operations STANDBY/ON PLAY MODE REPEAT FM MODE BASS TREBLE TREBLE BASS MD/AUX CANCEL TA/NEWS SEARCH SELECT /INFO DIMMER DISPLAY FM/AM MODE DIMMER SLEEP AHB PRO DISPLAY AHB PRO VOLUME +/– CLOCK OPEN/ COLOR /TIMER CLOSE COLOR VOLUME (VS-DT9R DISPLAY only) Turning the Power On and Off Turning the System On...
  • Page 16: Changing The Color (Color) (Vs-Dt9R Only)

    Basic Operations Changing the Color (COLOR) (VS-DT9R only) (Using the Remote Control) You can change the color of the illumination on the Unit. Press the % button to turn on the Sys- tem. Press the COLOR button on the Remote Control.
  • Page 17: Reinforcing The Bass Sound (Ahb Pro)

    Reinforcing the Bass Sound (AHB PRO) (Using the Remote Control) You can reinforce the bass sound to maintain rich, full bass at low volume. To get the effect, press the AHB (Active Hyper Bass) PRO button. The “AHB PRO” indicator lights up on the display. To cancel the effect, press the button again.
  • Page 18: Using The Tuner

    Using the Tuner STANDBY/ON Number PLAY MODE Buttons REPEAT FM MODE BASS TREBLE MD/AUX CANCEL TA/NEWS SEARCH SELECT /INFO PTY SEARCH DISPLAY FM/AM MODE DIMMER SLEEP FM/AM AHB PRO DISPLAY DISPLAY CLOCK OPEN/ COLOR /TIMER CLOSE MODE VOLUME * When the System is in use, the display shows other items as well. For simplicity, we show here only the items described in this section.
  • Page 19: Presetting Stations

    Presetting Stations (Using the Remote Control) You can preset up to 30 FM stations and up to 15 AM (MW/ LW) stations. • Preset numbers may have been set to factory test fre- quencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below.
  • Page 20: To Change The Fm Reception Mode

    Using the Tuner To Change the FM Reception Mode (Using the Remote Control) When you are tuned into an FM stereo broadcast, the “STEREO” indicator lights up and you can hear stereo ef- fects. If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode.
  • Page 21 To search for a programme by PTY codes One of the advantages of the RDS service is that you can locate a particular kind of programme by specifying the PTY codes. To search for a programme using PTY or TA codes: SEARCH SELECT Press the PTY SEARCH button once...
  • Page 22 Using the Tuner To temporarily switch to a broadcast programme of your choice “Enhanced Other Networks” is another convenient RDS service that allows this unit to switch temporarily to a broadcast programme of your choice (NEWS, TA or INFO) from the currently selected station, except if you are listen- ing to a non-RDS station (all AM (MW/LW) stations or some FM stations).
  • Page 23: Using The Cd Player

    Using the CD Player STANDBY/ON Number PLAY MODE PLAY MODE REPEAT buttons REPEAT FM MODE BASS TREBLE MD/AUX CANCEL TA/NEWS SEARCH SELECT /INFO DISPLAY FM/AM MODE DIMMER SLEEP AHB PRO DISPLAY CLOCK OPEN/ COLOR /TIMER CLOSE VOLUME OPEN/CLOSE * When the System is in use, the display shows other items as well. For simplicity, we show here only the items described in this section.
  • Page 24: To Unload A Cd

    Using the CD Player CAUTIONS: • DO NOT try to open or close the Panel by hands as it will be damaged. Press the OPEN/CLOSE button on the Remote Con- trol to open or close the Panel. • DO NOT try to insert another CD when a CD has been already loaded on the Unit.
  • Page 25: Random Play

    Press the Number button to select the track to program. Each time you press the Number button, the selected track is added to the program. • For the track number more than 10, press the +10 button then the Number button. Program order number PROGRAM (After 2 seconds)
  • Page 26: Using External Equipment

    Using External Equipment STANDBY/ON PLAY MODE REPEAT FM MODE BASS TREBLE MD/AUX CANCEL MD/AUX TA/NEWS SEARCH SELECT /INFO DISPLAY FM/AM DIMMER SLEEP MODE AHB PRO DISPLAY CLOCK OPEN/ COLOR /TIMER CLOSE VOLUME Listening to External Equipment You can listen to external equipment such as MD recorder, cassette deck or other auxiliary.
  • Page 27: Using The Timers

    Using the Timers STANDBY/ON PLAY MODE REPEAT FM MODE BASS TREBLE MD/AUX CANCEL TA/NEWS SEARCH SELECT /INFO DISPLAY FM/AM MODE DIMMER SLEEP AHB PRO DISPLAY CLOCK OPEN/ COLOR /TIMER CLOSE CLOCK VOLUME /TIMER * When the System is in use, the display shows other items as well. For simplicity, we show here only the items described in this section.
  • Page 28: Setting The Daily Timer

    Using the Timers Setting the Daily Timer (Using the Remote Control) Once you have set the Daily Timer, the timer will be acti- vated at the same time every day. The Timer indicator ( ) on the display shows that the Dai- ly Timer you have set is in effect.
  • Page 29: Setting The Sleep Timer

    Before turning off the System, prepare the music source selected in step 3. TUNER: Tune in to the desired station. Insert a CD. (Playback will start from the first track at Timer on.) Press the % % button to turn off the Sys- tem.
  • Page 30: Care And Maintenance

    Care And Maintenance Handle your CDs carefully, and they will last a long time. Compact Discs • Only CDs bearing this mark can be used with this System. How- ever, continued use of irregular shape CDs (heart-shape, octago- nal, etc.) can damage the System. •...
  • Page 31: Troubleshooting

    Troubleshooting • If you are having a problem with your System, check this list for a possible solution before calling for service. Symptom No sound is heard. Poor radio reception The CD skips. The CD does not play. Unable to operate the Remote Control. Operations are disabled.
  • Page 32: Specifications

    2.5 W (power save mode) Center Unit Dimensions* (CA-VSDT6R/CA-VSDT7R/CA-VSDT9R) 325 mm ✕ 86 mm ✕ 237 mm (W/H/D) Mass* (CA-VSDT6R/CA-VSDT7R) Approx. 3.9 kg (CA-VSDT9R) Approx. 4.0 kg * without Stand and Legs Dimensions for Installation (CA-VSDT6R/CA-VSDT7R/CA-VSDT9R) Vertical Position 325 mm...

Table of Contents