Reinforcing The Bass Sound; Adjusting The Bass And Treble Sounds - JVC CA-NXHD10R Instructions Manual

Reinforcing the Bass Sound

The richness and fullness of the bass sound is clearly
maintained regardless of how low you set the volume
—Active Hyper Bass Pro.
• You can use this effect only for playback.
• This function also affects the sound from headphones.
On the remote control ONLY:
To get the effect, press AHB PRO repeatedly until
"AHB 1" or "AHB 2" appears in the main display.
The BASS indicator lights up on the display.
• Each time you press the button, the Active Hyper Bass
Pro mode changes as follows:
AHB 1
AHB OFF
(canceled)
BASS indicator
Ex. When "AHB1" is selected
• "AHB 2" is more effective than "AHB 1."
To check the effect level, press AHB PRO once.
To cancel the effect, press AHB PRO repeatedly until
"AHB OFF" appears in the main display.
The BASS indicator goes off from the display.
AHB 2
AAC 128
BASS

Adjusting the Bass and Treble Sounds

You can adjust bass and treble sounds to your taste and
surroundings.
• You can use this effect only for playback.
• This function also affects the sound from headphones.
On the remote control ONLY:
1
Press TONE CONTROL to select "BASS" or
"TREBLE."
The selected tone control mode and the current setting
appear in the main display.
• Each time you press the button, the tone control
mode changes as follows:
BASS
2
Press VOLUME + or VOLUME – to adjust the
selected tone level.
• You can adjust the tone level within the range of –5
to +5.
Ex. "BASS" level is set to "+3"
3
Repeat steps 1 and 2 to adjust the other tone level.
4
Press TONE CONTROL to finish the setting.
• If you do not press the button for about 5 seconds, the
setting will be stored, then the source indication will
be resumed.
To check the current level, press TONE CONTROL
repeatedly.
– 15 –
TREBLE
Source indication
(canceled)