Selecting The Sources And Starting Play; Adjusting The Volume - JVC CA-NXHD10R Instructions Manual

Selecting the Sources and Starting Play

To select FM, AM (MW/LW) or external component as
the source, press TUNER/LINE repeatedly until "FM,"
"AM" or "LINE*" is selected.
• If the unit is in standby mode, the power automatically
comes on at the first press of the button.
• Each time you press the button, the source changes as
follows:
FM
FM : To tune in to the last received FM station.
AM : To tune in to the last received AM (MW/LW)
station.
LINE* : To use the external equipment connected to
the LINE IN terminal.
* If you have changed the source name of the external
component, the currently selected source name will appear
(see page 26).
• For more detailed tuner operations, see pages 17 to
23.
• For operating the external equipment, see pages 24 to
26.
To select the CD player as the source, press CD 3/8.
When the unit is in standby mode:
The unit automatically turns on.
When the unit is turned on:
"CD PLAY" appears in the main display for a while.
• Playback will start if a CD is on the CD tray.
• "CD NO DISC" will appear in the main display if a CD
is not loaded.
To stop playback, press 7.
• For more detailed operations, see pages 27 to 31.
To select the HDD (hard disk drive) as the source, press
HDD 3/8.
When the unit is in standby mode:
The unit automatically turns on.
When the unit is turned on:
"HDD PLAY" appears in the main display for a while.
• "HDD NO DATA" will appear in the main display if
nothing is recorded. (To record into the HDD, see pages
42 to 51.)
To stop playback, press 7.
• For more detailed operations, see pages 32 to 41.
AM
*
LINE

Adjusting the Volume

You can adjust the volume level only while the unit is
turned on.
To increase the volume, press VOLUME + .
To decrease the volume, press VOLUME – .
• You can adjust the volume within the range of 0 (silence)
to 50 (maximum).
• When you press and hold the button, the volume level
keeps changing.
For private listening
Connect a pair of headphones to the PHONES jack inside the front
door. No sound comes out of the speakers. Be sure to turn down
the volume before connecting or putting on the headphones.
If "CANNOT LISTEN!" appears in the main
display
During high-speed recording (PCM x2 REC, PCM x4 REC) (see
page 47), you cannot listen to any source, and therefore, cannot
adjust the volume level.
DO NOT turn off (in standby mode) the unit with the
volume set to an extremely high level; otherwise, the
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is in standby mode.
– 14 –
Continued