Operation; Burner Controls - Jøtul GI 550 DV Installation And Operation Instructions Manual

Operation

1. Your fireplace can be operated manually using the
On/Off/T-stat rocker switch or it can be automati-
cally controlled using an optional wall-mounted
thermostat or remote control device. A separate
switch is provided for the built-in forced air blower.
Familiarize yourself with the location and function
of the controls. Gas Valve and Burner controls are
located in the left compartment. Blower controls
are in the right hand compartment. See figs. 31 - 34.
Piezo Ignitor - Push button pilot light ignition.
Gas Control - Used to control the pilot light and
gas flow from the supply line.
Regulator - Allows you to adjust heat output and
flame intensity from maximum down to 50%.
ON/OFF/ T'STAT Switch - Allows for manual or ther-
mostatic control of the burner.
Always follow the Lighting Instructions located
on the inside Back Cover of this manual and also
on the Rating Plate, located in the burner controls
compartment.
2. For the first several hours of operation, it is com-
mon to detect some odor as the metal and manu-
facturing materials cure under heat. This condition
is temporary and can be alleviated by allowing
plenty of fresh air to circulate through the area.
3. Condensation may develop on the glass upon each
lighting of the appliance. This "fog" will disappear
as the glass heats.
4. Keep the controls and the area under the appliance
free of debris; vacuum this area frequently, espe-
cially if you have pets. Always keep the appliance
area clear and free from combustible materials,
gasoline and other flammable liquids.
When a vacuum is used on any service for the fire-
place, ALWAYS be sure the fireplace is completely
cold.
5. This fireplace utilizes a continuously burning pilot
flame. Exercise caution when using household
products containing combustible vapors.
6. CAUTION: DO NOT OPERATE THIS APPLIANCE
WITH THE GLASS REMOVED, CRACKED OR BROKEN.
REPLACEMENT OF THE GLASS SHOULD BE DONE BY
A LICENSED OR QUALIFIED SERVICE PERSON. USE
ONLY REPLACEMENT GLASS PROVIDED BY YOUR
AUTHORIZED JØTUL DEALER. NEVER USE ANY SUB-
STITUTE MATERIALS.
Figure 31. The pilot assembly is located on the left side,
under the rear log.
Piezo Ignitor
Regulator
TP TH TP TH
Figure 32.
GI 550 DV Gas Valve and Regulator.
WARNING:
OBSERVE CAUTION NEAR THE GLASS PANEL. THE
GLASS MAY SHATTER IF STRUCK BY AN OBJECT. AL-
WAYS HANDLE THE GLASS PANEL WITH CARE.
138727_Rev_F 8/9/11
Gas Control
Knob
23