Ezgo RXV ELECTRIC Service & Repair Manual page 56

ELECTRONIC SPEED CONTROL (AC MOTOR)
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
ness to the upper terminal of the solenoid, secure in
place with a hex nut (6).
10. Reinstall the splash shield.
Replace worn or damaged hardware as required.
Red Wire to
Battery BL+
Resistor
Heatsink
Red Wire from
Solenoid to
Controller B+
Controller
Controller
(Ref Fig. 5)
Tool List
Ratchet ........................................................................ 1
Extension, 3" ............................................................... 1
Extension, 9" ............................................................... 1
Socket, 15 mm............................................................. 1
Socket, 10 mm............................................................. 1
Torx Bit, T-27 IP ........................................................... 1
Wrench, 10 mm ........................................................... 1
Page E-4
Resistor
Sensor
Solenoid
Fig. 5 Controller
Repair and Service Manual
ITEM
7
Wire to
Resistor
Wrench, 15 mm............................................................1
Notched Pry Bar ..........................................................1
Qty.
Insulated Wrench, 9/16"...............................................1
Pin Punch ....................................................................1
Using an insulated wrench, disconnect the bat-
tery cable at the negative (-), BL-, battery ter-
minal.
TORQUE SPECIFICATION
44 - 62 in. lbs (5 - 7 Nm)
Splash Shield