REAR AXLE
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
Fig. 6 Press Bearing from Shaft
4. Remove the inner snap ring.
Use care to prevent damage to the inner surface of the
axle tube at the seal area.
5. Remove the oil seal using a seal puller.
Fig. 7 Oil Seal Removal
6. Install the new oil seal using the seal installer (E-Z-GO
P/N 18739-G1) to drive the seal into its correct posi-
tion.
Fig. 8 Seal Installation
Page M-4
7. Install the inner snap ring.
Bearing
To prevent damage to the oil seal, lightly coat the axle
Separator
shaft with bearing grease and support the shaft during
installation.
8. Carefully insert the axle shaft and bearing through the
9. Install the outer snap ring.
Install the rear hub according to the instructions in the
Rear Hub section.
Repair and Service Manual
oil seal. Rotate the shaft until the spline engages with
the differential side gears.