Ezgo RXV ELECTRIC Service & Repair Manual page 38

BODY
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
3. Loosen the torx head bolts (23) and nuts (22) (Ref.
Fig. 15) that secure the seat back mounting brackets
and hip restraint to the seat back support (14).
4. Slide the seat back assembly (15) with the brackets
attached towards the back of the vehicle and remove
it from the vehicle.
5. To separate the seat back assembly (15) from the
mounting brackets (17) remove the four torx head
screws (16), two from each bracket.
Fig. 13 Rear Facing Seat Back
6. Remove the hex head bolt (20) and nut (21) from the
lower leg of the driver side hip restraint.
Fig. 14 Rear Facing Seat Hip Restraint
7. Remove the hex nuts (22) from the torx head bolts
(23) that secure the driver side hip restraint to the seat
back support.
8. Hold or support the hip restraint before removing the
torx head bolts (23), once these bolts are removed the
hip restraint is free from the vehicle.
Page C-8
9. Repeat steps 6 - 8 for the removal of the passenger
side hip restraint.
10. Remove four torx head bolts (25) that secure the front
seat back to the seat back support bracket.
11. Remove two torx head bolts (28) from the bagwell
floor.
12. Loosen four hex head bolts (30). Support the rear foot
rest (29) before removing the two bolts closest to the
Repair and Service Manual
Fig. 15 Upper Hip Restraint Bolts
Fig. 16 Front Seat Back
Fig. 17 Rear Facing Seat Foot Rest