Main Wiring Harness - Ezgo RXV ELECTRIC Service & Repair Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
CHARGER RECEPTACLE
BATTERY BANK

MAIN WIRING HARNESS

The Main Electrical Harness for the vehicle is routed
under the floormat, recessed into the floorboard, the for-
ward section runs under the instrument panel into clips
on the front splash shield, the rear section runs under
the rear body and in front of the batteries. The harness
has the Run/Tow switch, the Solenoid, and the Reverse
Warning Indicator hard wired into the harness.
Replacing the Main Wiring Harness
Tool List
Notched Pry Bar .......................................................... 1
Torx Bit 27 IP ............................................................... 1
Insulated Wrench, 9/16" .............................................. 1
ELECTRICAL COMPONENTS & WIRING
DIAGNOSTIC PLUG
WIRING HARNESS
Fig. 1 Main Electrical Harness
Using an insulated wrench, disconnect the bat-
tery cable at the negative (-), BL-, battery ter-
minal.
To access the main wiring harness for replacement it is
necessary to remove the upper and lower rocker panels,
the floormat, the pedal cover, the front cowl, the top por-
tion of the cup holder and the seat bottom. See the Body
Section in this manual for instructions on removal and
replacement of these items.
1. Disconnect the main wiring harness from the battery
Qty. pack using an insulated wrench.
2. Drain the stored energy from the controller. Place the
Run/Tow switch in the 'Run' position, turn the key
switch to reverse, wait for the reverse warning indica-
tor to become silent then turn the key switch to the off
position and remove it from the switch.
3. Locate the tab under the cowl that extends from the
Repair and Service Manual
B
B
MOTOR
Page K-1