Ezgo RXV ELECTRIC Service & Repair Manual page 105

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
22. Remove the two torx head screws (10) securing the
reverse warning indicator (11) to the splash shield.
Fig. 5 Reverse Warning Indicator
23. Remove hex nuts (16) and disconnect the red wire to
the positive battery, BL+, terminal (20) and the yellow
wire (17) to the wire harness from the upper post of
the solenoid (18). Remove the red wire (19) from the
controller B+ terminal from the lower post of the sole-
noid (18) and the white wire from the resistor (21).
Heatsink
Red Wire from
Solenoid to
Controller B+
Controller
Fig. 6 Solenoid Removal
24. Remove two hex head bolts (22) securing the sole-
noid (18) to the controller heat sink.
25. Unplug the connectors from the motor brake (23), the
motor temperature sensor (24) and the motor sensor
(25).
ELECTRICAL COMPONENTS & WIRING
Splash Shield
Repair and Service Manual
Fig. 7 Motor Connections
26. Remove main wiring harness from the vehicle.
27. Install new main wiring harness making sure that it fol-
lows the proper path.
a) Starting in the middle of the vehicle, route the for-
ward section of the harness under the rear body in
the floorboard channels (1, 2 & 3).
b) Route the connections for the brake and accelera-
tor pedals, making sure that the harness lays in the
recessed floorboard channels.
Fig. 8 Harness Routing & Pedal Connections
c) Connect the wires to the accelerator rotary position
sensor (5) and the throttle enable switch connector
(4).
d) Place pedal assembly in position on the floorboard
and secure with three Torx screws (6).
B
B
MOTOR
Page K-3