Sweater Basket; Seat Back Assembly - Ezgo RXV ELECTRIC Service & Repair Manual

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
Fig. 10 Golf Car Rear Body, Sweater Basket, Rear Bumper & Fender Liner

Sweater Basket

(Ref. Fig. 10)
Tool LIst
Torx Bit, T-47IP............................................................ 1
Socket, 15 mm Deep-well ........................................... 1
Ratchet ........................................................................ 2
Ratchet Extension, 6".................................................. 1
Torque Wrench, ft. lbs. ............................................... 1
1. Remove four torx screws (28) and flanged nuts (29)
on the top edge of the sweater basket assembly (27).
2. Remove two torx screws (30) securing the back of the
sweater basket to the seat back supports.
3. Slide the sweater basket assembly (27) off the seat
back supports.
Installation of the sweater basket is in reverse order
of its removal. Replace any worn or damaged hard-
ware with new as required. It is recommended that
all locking nuts be replaced after 5 removals.
ITEM
Qty.
29
30

Seat Back Assembly

Tool LIst
Torx Bit, T-45IP ............................................................1
1. Remove four torx screws (26) that secure the seat
back assembly (25) to the support struts.
Installation of the seat back assembly is in reverse
order of its removal. Replace any worn or damaged
hardware with new as required. It is recommended
that all locking nuts be replaced after 5 removals.
Repair and Service Manual
TORQUE SPECIFICATION
4 - 6 ft. lbs. (6 - 8 Nm)
13 - 16 ft. lbs. (18 - 22 Nm)(
B
BODY
B
Qty.
Page C-5