5.4 Changing acceleration and deceleration time (Pr. 7, Pr. 8)
Set in Pr. 7 Acceleration time a larger value for a slower speed increase and a smaller value for a faster speed increase.
Set in Pr. 8 Deceleration time a larger value for a slower speed decrease and a smaller value for a faster speed decrease.
Parameter
Name
Number
7
Acceleration time
8
Deceleration time
* Depends on the Pr. 21 Acceleration/deceleration time increments setting. The initial value for the setting range is "0 to 3600s" and setting increments is
"0.1s".
Changing example
Change the Pr. 7 Acceleration time setting from "5s"
to "10s".
1.
Screen at power-ON
The monitor display appears.
2.Operation mode setting
Press
mode.
3.
Press
to choose the parameter
setting mode.
4.
5.
Press
to read the present set value.
"
"(initial value) appears.
6.
Turn
to change it to the set
value "
7.
Press
to set.
REMARKS
If torque is required in low-speed range (rated motor frequency (refer to page 44) /10), set Pr.791 Acceleration time in low-speed
range and Pr.792 Deceleration time in low-speed range higher than the Pr.7 and Pr.8 settings so that the slow acceleration/
deceleration is performed in the low-speed range. (Refer to the Instruction Manual (Applied) for Pr.791 and Pr.792)