Initial Value Change List - Mitsubishi Electric FR-F720P-0.75K Instruction Manual

Initial value change list

5.9 Initial value change list
Displays and sets the parameters changed from the initial value.
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Operation mode setting
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Pressing changes to the initial value
SET
change list screen.
6.
Turning displays the parameter number
changed.
Press to read the present set value.
SET
Turn and press
setting
(refer to step 6 and 7 on page 51)
Turn to read another parameter.
The display returns to
parameters are displayed.
7.
Pressing in
SET
the parameter setting mode.
Turning
Pressing
REMARKS
Calibration parameters (C0 (Pr. 900) to C7 (Pr. 905), C42 (Pr. 934) to C45 (Pr. 935)) are not displayed even they are changed from
the initial settings.
Only simple mode parameter is displayed when simple mode is set (Pr. 160 = 9999 (initial value))
Only user group is displayed when user group is set (Pr. 160 = "1").
Pr. 160 is displayed independently of whether the setting value is changed or not.
82
appears.
SET
SET
to change the
SET
after all
status returns to
SET
sets other parameters.
displays the change list again.
SET
Display
PU indicator is lit.
PU
PRM indicator is lit.
(The parameter number read previously appears.)
SET
Flicker Frequency setting complete!!
···
EXT NET