Sending The Prn File; Restarting This Machine; Troubleshooting - Konica Minolta magicolor 8650 User Manual

Appendix
18.4.3

Sending the PRN file

1
Send the PRN file created in "Creating tray mapping definition PRN file" on page 18-11 to this machine
using the lpr command.
2
Start the command prompt, and then execute the following command.
lpr –S (IP address of this machine) –P printer (PRN file created in "Creating tray mapping definition PRN
file" on page 18-11)
18.4.4

Restarting this machine

% Turn off the main power of this machine, then on again.
The settings are enabled after restarting.
Note
When the power is turned off, then on, turn off the power, wait at least 10 seconds, and then turn it on.
Otherwise, the machine may not operate correctly.
18.4.5

Troubleshooting

After turning on the power, the settings are checked.
When any error is found during checking, all the settings are disabled (initial settings are kept valid).
Even if an error exists, no error message appears.
Possible error causes are as follows.
- Actual number of trays is less than the number of trays defined.
HPTRAY5E=1, 2
- A PCLID that is not a number is defined.
HPTRAY5E=1, 2, 3, A, 5, 6, 8
- A PCLID that is out of available range is defined.>
HPTRAY5E=1, 2, 3, 500, 5, 6, 8
- A redundant PCLID is defined.
HPTRAY5E=1, 2, 3, 2, 5, 6, 8
- The PCLID for Auto Tray is specified for any other tray.
HPTRAY5E=1, 2, 3, 4, 5, 6, 7
magicolor 8650
18
18-13