Engine Oil/Oil Filter - KYMCO Downtown 200i Service Manual

4. LUBRICATION SYSTEM

ENGINE OIL/OIL FILTER

• Place the scooter upright on level ground
for engine oil level check.
• Run the engine for 2～3 minutes and check
the oil level after the engine is stopped for
2～3 minutes.
Remove the oil dipstick and check the oil level
with the oil dipstick.
If the level is near the lower level, fill to the upper
level with the recommended engine oil.
OIL CHANGE
• The engine oil will drain more easily while
the engine is warm.
Remove the oil drain bolt located at the left side
of the engine to drain the engine oil.
After the oil has been completely drained, install
the aluminum washer and tighten the oil drain
bolt.
Torque: 24.5 N-m
Pour the recommended oil through the oil filler
hole.
OIL FILTER SCREEN
Drain the engine oil.
Remove the oil filter screen cap.
Remove the oil filter screen and spring.
Check the oil filter screen for clogging or damage
and replace if necessary. Check the filter screen
O-ring for damage and replace if necessary.
Install the oil filter screen, spring, O-ring and
filter screen cap.
Torque: 12.7N-m
Recommended Oil: SAE5W50# API: SJ
Oil Capacity:
At disassembly: 1.5 liter
At change: 1.3 liter
Start the engine and check for oil leaks. Start
the engine and let it idle for few minutes, then
recheck the oil level.
4-3
DOWNTOWN 200i
Oil Dipstick