Display Section - Sony SRW-5001 Operation Manual

2-1 Control Panel
4 REC/EDIT (recording/edit) button
Press this button while holding down the PLAY button
to start recording.
If you press this button in play mode, manual editing
begins. After setting edit points, if you press this
button while the AUTO button is lit, automatic editing
is performed.
5 PLAY button
Press to start playback.
Press this button while holding down the REC/EDIT
button to start recording.
Pressing this button during recording or manual editing
changes the VTR to playback mode.
6 STOP button
Press this button to stop recording or playback.
When you insert the cassette, the VTR automatically
enters STBY OFF mode.
The STOP button flashes in the following cases.
• The [F2] (SERVO REF) button in the PF1 menu is set
to "input" but there is no video input signal.
• The [F2] (SERVO REF) button in the PF1 menu is set
to "ext" but there is no external reference video
signal.
• The input signal is out of synchronization with the
external reference video signal.
You can change the setting of the VTR SETUP menu
item 102 "REFERENCE SYSTEM ALARM" so that
the STOP button will not flash in these cases.
2-8
Chapter 2 Locations and Functions of Parts

4 Display Section

1 OEL display
SYS: 59.94i 1080 4:2:2 HDCAM SR
PB : _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
TCR 00:12:37:28
REC
INHIBIT SERVO PREREAD
4 SERVO indicator
5 REC INHIBIT indicator
1 OEL display
This shows the following.
SYS: Shows the recording system information (signal
standard and tape format).
PB: Shows the information recorded on the tape
(signal standard and tape format) while being
played back.
FC: Shows the converted signal standard when an
HKSR-5001 board is installed.
TCX: Shows the LTC/VITC and DF/NDF settings,
or the time code sent to the external monitor.
2 REF SYNC (reference signal) indicators
These indicate the signal selected as the reference
signal. If there is no reference signal input to the
selected connector, the STOP button flashes.
EXT SD: Lights when "extern SD" is selected by the
VTR SETUP menu item 006 "EXTERNAL
REFERENCE select".
EXT HD: Lights when "extern HD" is selected by
the VTR SETUP menu item 006 "EXTERNAL
REFERENCE select".
INPUT VIDEO: Lights when "INPUT" is selected
by the VTR SETUP menu item 005 "SERVE/AV
REFERENCE select".
3 PREREAD indicator
Lights up during preread mode.
For more information about PREREAD, see "6-2-3 Preread
Editing" on page 6-15.
4 SERVO indicator
Lights up when the drum servo and capstan servo are
locked.
2 REF SYNC indicators
REF SYNC
EXT EXT INPUT
SD HD VIDEO
3 PREREAD indicator