Upper Control Panel - Sony SRW-5001 Operation Manual

2-1 Control Panel

2-1-1 Upper Control Panel

1 POWER switch
2 ERROR indicator
POWER
ERROR WARNING
PHONES
CONDITION
8 PHONES level control
9 PHONES jack
1 POWER switch
Pressing on the '(' side of this switch powers the unit
and lights up the OEL display (page 2-8) and color
display (page 2-5). To turn the unit off, press on the
'a' side of the switch.
2 ERROR indicator
This lights when a serious problem occurs, such as an
operational malfunction or system internal error.
You can check the details on the lower control panel.
For details, see "Error Messages and Warning Messages"
on page A-5.
3 WARNING indicator
This flashes when there is a fault in the unit. You can
check the details on the lower control panel.
For details, see "Error Messages and Warning Messages"
on page A-5.
4 EJECT button
Pressing this button automatically ejects the cassette
after several seconds.
2-2
Chapter 2 Locations and Functions of Parts
3 WARNING indicator
4 EJECT button
5 Format indicators
EJECT
REMOTE
CHANNEL
ETHERNET 1(9P) 2(50P)
6 REMOTE buttons
7 CHANNEL CONDITION indicators
SRW-5000
HD DIGITAL VIDEO CASSETTE RECORDER
Cassette compartment
5 Format indicators (Digital BETACAM/
HDCAM/HDCAM SR)
These show the format of the cassette loaded into the
unit.
6 REMOTE buttons
Press these buttons to select external equipment to be
used to remotely control the VTR.
ETHERNET: This button lights when access from
the network connected to the ETHERNET
connector on this unit is enabled.
1(9P): Press to select the unit connected to the
REMOTE 1-IN(9P) or REMOTE 1-I/O (9P)
connector. The button lights up.
2(50P): Press to select the unit connected to the
PARALLEL I/O (50P) connector (with optional
HKSR-5003). The button lights up.
Note
When the VTR is being controlled by the external
equipment connected to the REMOTE1-IN (9P) or
REMOTE 2 PARALLEL I/O (50P) connector, all tape
transport buttons and edit operation buttons are
disabled, except the STOP and EJECT buttons. You
may also specify the disabling or enabling of all
buttons by setting the VTR SETUP menu item 008
"LOCAL FUNCTION ENABLE".