Sony SRW-5001 Operation Manual page 104

4-7 SET UP Menu
Selecting remote operation mode
When operating the VTR with an external device, set
the ALT/[F7] (NETWORK) buttons, ALT/[F8]
(REMOTE 9-PIN) buttons or ALT/[F9] (REMOTE 50-
PIN) buttons to "on".
When the ALT/[F7] (NETWORK) buttons are
set to "on"
You can operate this unit from a computer or similar
through the network to which the ETHERNET
connector is connected.
When the ALT/[F8] (REMOTE 9-PIN) buttons
are set to "on"
You can operate the VTR with a device connected to
the REMOTE 1-IN(9P) or REMOTE 1 I/O(9P)
connector.
When the ALT/[F9] (REMOTE 50-PIN) buttons
are set to on
You can operate the VTR with a device connected to
the REMOTE 2 PARALLEL I/O(50P) connector.
Note
When operating the VTR through an external device
with the ALT/[F8] or ALT/[F9] buttons set to "on", all
of the tape operation and editing buttons are disabled,
with the exception of the STOP and EJECT buttons.
You may also set the VTR so that all buttons are
enabled or disabled. Perform this setting using the
VTR SETUP menu item 008 "LOCAL FUNCTION
ENABLE". You cannot, however, disable the menu
and remote operation mode selection buttons.
4-64
Chapter 4 Menu Settings