Motorola B3 MTX Series Operating Instructions Manual page 31

MAEPF-22067-A MAEPF-22068-A
17 General Radio Features Operation
The radio will emit an alert tone to indicate a low-battery condition if the
battery voltage falls below the low-voltage level. When the radio is transmitting,
the tone is emitted when the PTT is released; when the radio is receiving, the
tone is emitted when the low-battery condition is detected.
The scan feature allows you to monitor activity on
different trunked or conventional modes by scanning a
"scan list" of modes. The list can contain up to 16
members, and can be programmed with the radio
service software (RSS).
All MTX Series radios support automatic scanning
(autoscan), which is programmed into the radio
through the RSS. With this feature, the radio begins
scanning whenever you select a mode to which a scan
list is assigned (strapped). The radio will continue
autoscanning until you select a mode that does not
have autoscan enabled.
Turning Scan On/Off
1. To turn scan on, place the toggle switch in the "B"
(scan on) position. The radio begins scanning.
2. To turn scan off, place the toggle switch in the "A"
(scan off) position. The radio stops scanning.
17