Table of Contents
Advertisement
Error Messages
Reports
Help
If your unit cannot send a fax, check the following:
– The number you dialed is correct.
– The other party's machine is a fax machine.
If the problem remains, correct it by following the communication message printed on the sending and
journal reports (page 56).
COMMUNICATION ERROR
(Code: 40-42, 46-72, FF)
L A transmission or reception error occurred.
Try again or check with the other party.
COMMUNICATION ERROR
(Code: 43, 44)
L A line problem occurred. Connect the
telephone line cord to a different jack and try
again.
L An overseas transmission error occurred. Try
using the overseas mode of feature #23
(page 92).
DOCUMENT JAMMED
L The document is jammed. Remove the
jammed document (page 109).
ERROR-NOT YOUR UNIT
(Code: 54, 59, 70)
A transmission or reception error occurred
because of a problem with the other party's fax
machine. Check with the other party.
JUNK FAX PROH. REJECT
L The Junk Fax Prohibitor of your fax machine
rejected fax reception.
MEMORY FULL
L The document was not received as a result of
the memory being full.
NO DOCUMENT
L The document was not fed into the unit
properly. Reinsert the document and try
again.
OTHER FAX NOT RESPONDING
L The other party's fax machine is busy or has
run out of recording paper. Try again.
L The document was not fed properly. Reinsert
the document and try again.
L The other party's fax machine rings too many
times. Send the fax manually (page 55).
L The other party's machine is not a fax
machine. Check with the other party.
L The number you dialed is not in service.
PRESSED THE STOP KEY
L { { { { STOP} } } } was pressed and fax
communication was cancelled.
96
OK
L Fax communication was successful.
Advertisement
Table of Contents
