Reports - Panasonic KX-FP181 Operating Instructions Manual

Error Messages

Reports!

If your unit cannot send a fax, check the following.
– The number you dialled is correct.
– The other party's machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the
sending and journal reports (p. 32).
Communication message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
MEMORY FULL
NO DOCUMENT
OTHER FAX NOT RESPOND
PRESSED THE STOP KEY
THE COVER WAS OPENED
OK
72
Error
code
40–42 A transmission or reception error occurred. Try
46–52 again or check with the other party.
58, 65
68, 72
FF
43 An overseas transmission error occurred. Try using
44 the overseas mode (feature #23 on page 67).
— The document is jammed. Remove the jammed
document (p. 81).
54 A transmission or reception error occurred
59 because of a problem with the other party's fax
70 machine. Check with the other party.
— The document was not received due to memory
being full.
— The document was not fed into the unit properly.
Reinsert the document and try again.
— The other party's fax machine is busy or has run
out of recording paper. Try again.
The document was not fed properly. Reinsert the
document and try again.
The other party's fax machine rings too many
times. Send a fax manually – dial the number,
confirm the fax tone, and press
The other party's machine is not a facsimile.
Check with the other party.
The number you dialled is not in service.
STOP
—
cancelled.
— The covers were opened. Close them and try
again.
— Fax communication was successful.
Cause & Remedy
was pressed and fax communication was
FAX START
.