Basic Settings; Adjusting The Front Speaker Output Balance; Listening At Low Volume (Loudness); Using The Sleep Timer - JVC RX-664VBK Instructions Manual

Basic Settings

Some of the following settings are required after connecting and positioning your speakers in your listening
room, while others will make operations easier.

Adjusting the Front Speaker Output Balance

If the sounds you hear from the front right and left speakers are unequal, you can adjust
the speaker output balance.
On the front panel only :
1. Press SETTING so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # #
buttons work for adjusting the balance.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until "BALANCE" appears on
the display.
3. Press Control @ @ @ @ @ / # # # # # to adjust the balance.
• Pressing Control @ decreases the right channel
output.
• Pressing Control # decreases the left channel output.

Listening at Low Volume (Loudness)

Human ears are not sensitive to bass at low volume. To compensate for this, the
Loudness function automatically boosts the bass level as you lower the volume.
On the front panel only :
1. Press SETTING so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # # buttons work for setting the
Loudness function.
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until "LOUDNESS" appears on the display.
3. Press Control @ @ @ @ @ / # # # # # to set the Loudness function to "ON" or "OFF."
• Select "ON " to activate the Loudness function.
The LOUDNESS indicator lights up on the display.
• Select "OFF" to cancel it.
The indicator goes off.

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off
by itself rather than play all night.
On the front panel:
1. Press SETTING so that the Control % % % % % / fi fi fi fi fi / @ @ @ @ @ / # # # # # buttons work for setting the
Sleep Timer
The lamp above the button lights up.
2. Press Control % % % % % / fi fi fi fi fi until "SLEEP" appears on the display.
3. Press Control @ @ @ @ @ / # # # # # to set the shut-off time.
The SLEEP indicator lights up on the display.
Each time you press the button, the shut-off time on the display changes as follows:
10 20
17
30 40 50
0
(Canceled)
SETTING
60 70 80
Note:
If the balance is not set at the
center, "BALANCE @ " or
"BALANCE # " will appear in
step 2.