Exiting The Diagnostics Mode; Dual Diode Adjust - Lexmark C792 series Service Manual

Par 1 Strobe Adj (if installed)
EP SETUP
EP Defaults
Fuser Temp
DC Charge Adjust
Dev Bias Adj
Transfer Adjust
Op Point Boost
REPORTS
Menu Settings Page
EVENT LOG
Display Log
Print Log
Clear Log
Exit Diags

Exiting the Diagnostics mode

Select Exit Diags to exit the Diagnostics mode and return to the printer home screen.

DUAL DIODE ADJUST

Adjust the dual diode alignment before adjusting the Registration or Alignment settings.
1.
From the Diagnostics menu, navigate to:
DUAL DIODE ADJUST > Diode Alignment Page
An alignment page prints.
2.
Follow the instructions on the alignment page and use the touch screen to adjust the dual diode alignment
for Black, Cyan, Magenta, and Yellow.
3.
Reprint the alignment page and adjust the settings as needed.
See "Par 1 Strobe Adj" on page
See "EP Defaults" on page
See "Fuser Temp" on page
See "DC Charge Adjustment" on page
See "Dev Bias Adj" on page
See "Transfer Adjust" on page
See "Op Point Boost" on page
See "Display Log" on page
See "Print Log" on page 3-25.
See "Clear Log" on page 3-25.
3-24.
3-24.
3-24.
3-24.
3-24.
3-24.
3-24.
3-24.
Diagnostic aids
5062
Previous
Next
Go Back
3-9