Serial Interface Parameters - SATO E series Programming Manual

Serial Interface Parameters

COMMAND STRUCTURE
COMMAND FUNCTION
INPUT TO PRINTER
PRINTER OUTPUT
SPECIAL NOTES
SATO Programming Reference
Section 6: Configuration Commands
<ESC>I2abcde
a = 0 Baud rate, 9600 bps
1 Baud Rate, 19200 bps
2 Baud Rate, 38400 bps
3 Baud Rate, 57600 bps
b = 0 8 Data bits
1 7 Data Bits
c = 0 No Parity
1 Odd Parity
2 Even Parity
d = 0 1 Stop Bit
1 2 Stop Bits
e = 0 Single Item Buffer
1 Multi Item Buffer
2 X-On/X-Off Flow Control
3 Bi-Com 4
4 Bi-Com 3
Example: See above
Placement: Separate data stream sent to printer
Default: Default value set by <ESC>PC command
To set the operating parameters of the RS232 Inferface for a job.
<ESC>
<ESC>I230011
<ESC>Z
There is no printer output as a result of this command.
1. The setting are stored in the EEPROM by this command and
they will remain in effect until a new <ESC>I2 command is
received. Cycling power will have no effect on these settings.
2. To change the value stored in the EEPROM, use the
<ESC>PC Printer Setting command or use the Printer Set-
ting Utility program contained on the CDROM shipped with
the printer.
3. All command parameters must be present in the data stream
sent to the printer.
4. Selecting X-On/X-Off, Bi-Com3 or Bi-Com4 will automatically
place the printer in the Multi Buffer mode.
Page 6-11